Neunaber Iconoclast Speaker Emulator
Iconoclast dynamically shapes your tone as a speaker cabinet would yet outputs directly to headphones, powered speakers, a mixer or recording interface. When paired with the drive pedal or preamp of your choice, Iconoclast delivers consistent amp tone at any volume—and in virtually any setting—often without needing to bring anything more than your pedal board.
Intuitive controls make it easy to dial in a wide range of tones on-the-fly, whether or not you know anything about how different speaker cabs sound. The Low, Mid and High controls work pretty much like they appear. It doesn’t need to get any more complicated than this.
For you tone nerds, however, there’s a lot more going on under the hood:
- Low adjusts the virtual cabinet type and size
- Mid captures the speaker’s dynamic interaction with the amplifier
- High shifts the frequency cut off, reproducing a wide range of speaker types
On top of this, Iconoclast Software for Windows/Mac lets you dig deep into the inner workings, visualize how your tone is being shaped, and change the response to your heart’s content. The software also adds a mono-compatible stereo enhancer for your listening pleasure.
Iconoclast was designed to be the only thing you need after your pedal board or preamp, so we also added a studio-quality noise gate to clean up your dirty signal chain. Flexible ins & outs may be used mono or stereo, and the outputs can be used balanced or unbalanced. Or just plug in your headphones—with its built-in headphone amp, Iconoclast can handle that too.
At only 4.6” × 2.8” (116 mm × 68 mm), Iconoclast can fit almost anywhere and is powered by your existing 9V or 12V pedal board power supply (not included).